Lathe

The Basics

We've got an APTC 460 lathe. Vital statistics are as follows:

• 1.5hp motor
• 250/650/900/1700 RPM
• 100mm chuck
• 460mm between centers
• MT2 tailstock (currently fitted with a 13mm drill chuck)

Our lathe is suitable for turning metals and plastics. Aluminium, brass, copper, delrin/acetal and nylon shouldn't present any problems. It should be possible to machine mild steel too, though you may find some additional cooling is necessary.

Safety

• Always ensure the chuck key is removed before attempting to operate the lathe.
• Ensure the work is securely fixed in the chuck.
• The lathe will not run unless the guards are in place - this is for your safety, do not try to defeat this.
• Swarf is SHARP - gloves are available in the box by the lathe.
• Don't attempt to start drilling holes with a normal drill in the tailstock chuck - use a centre drill to create a pilot hole first.
• Go and check you removed the chuck key again.

Tools

We currently have:

• 2 cutting tools in the tool post
• 13mm drill chuck in the tailstock

We need:

• Center drills
• Cutting tools (left and right hand roughing, finishing, facing, plus parting off)

We'd like:

• Quick change tool post
• Cutting tools (boring bar)
• Live center (MT2)
• Knurling tool