Projects/Big Ass-LED Display

The "Big-Ass" LED displays are a pair of four 80 x 60 pixel RGBG panels (160 x 120 total subpixels) which were originally installed in the O2 Academy Leeds. These can be stacked to create a 320 x 240 subpixel display, approximately 10 ft x 10 ft across. Total power consumption varies depending on the image, but is estimated around 400 watts for the whole setup for average video content.

At some point during the repair of one display module, some connectors were accidentally transposed. This led to the shorting of one of the 5V, 170A power supplies inside the units causing the destruction of modules and wiring harnessess. Phil, a member, donated them to the space after the Academy scrapped them.

Each panel is composed of 150 separate display modules which are essentially giant shift registers. Driving the display is not trivial. The original design uses a complex board with an FPGA, CPLD and several kilobytes of SRAM to drive just half of one panel. A control cabinet, a 4U rackmount unit, converts composite (CVBS) video into AMD TaXiCHIP format (yes, that AMD, before they focused on just making CPUs and GPUs.) This data is sent over a fibre-optic link - this is presumed to eliminate ground loops as the data rate is not that fast and coax would have been sufficient.

The 4U rackmount cab has an issue, where the 3.3V rail is low on power on. So it will not display video for about 30 minutes until it has warmed up. It will display only a blue screen for no signal, or black, regardless of signal, in this state. The 3.3V LED on the front of the unit will also be visibly dimmer than the other LEDs. There is a basic serial terminal at 9600 baud but it has no test pattern functions or methods to load data into. The rack contains several more FPGAs and framebuffer/control ICs.