Electronics/MegaPA310
| File:MegaPA310.JPG | |
| PCB processing tank (etch tank) | |
| Equipment Information | |
|---|---|
| Status | Unknown |
| Manufacturer | Mega |
| Model | PA310 |
| Hackspace Information | |
| Induction Required | Yes |
| Induction Information | Here |
| Card RFID Enabled | No |
| Owner | LHS |
The Basics
MEGA PA310 Tri-Tank Unit for Printed Circuit Board (PCB) processing. A self-contained triple process unit with built-in DEVELOP / SPRAY WASH / BUBBLE ETCHING functions.
Specification
- MEGA PA310 Tri-Tank Unit
- Moulded 13amp plug (kettle lead)
- Two syphons
- Front panel tank control
- Connections provided at the rear for drain and cold water requirements.
- Width 400mm, Depth 525mm, Height 380mm.
Safety
You must read the safety documentation in this link before using this equipment.
Safety is very important when using this equipment, you must also read the safety information below. This is the basic information, you are expected to do further research into the area yourselves before using the equipment.
- You must read and be familiar with the safety datasheets for all chemicals you use, eg developer / etchant.
- MORE TBD ***
Induction
Ask on the mailing list for volunteers to demonstrate the use of the equipment.
Use
Producing a PCB https://www.megauk.com/producing_a_pcb.php
WARNING: Using the WRONG ARTWORK FILM in a laser printer can cause it to melt and stick inside the printer damaging the printer - an expensive mistake!
We also have a UV exposure unit for exposing photoresist type PCB.
Useful References
- Youtube has many tutorials on UV exposure of PCBs