6040 Laser Cutter: Difference between revisions

From Leeds Hackspace Wiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 23: Line 23:
* Corrugated card (fire risk)
* Corrugated card (fire risk)
* Food (it smells horrible and gunges up the laser)
* Food (it smells horrible and gunges up the laser)
Stuff that *might* be etchable (this will be covered in induction):
* Metal
* Glass
* Ceramics
All of the above need their reflectiveness dealing with or you could damage the laser.
Anything not mentioned above, ask a Laser-inducted director and do not be surprised/upset when they say "hell no!".


== Maintenance ==
== Maintenance ==

Revision as of 23:16, 16 February 2015

About

NewLaser-workshop-page.jpg

In December 2014 we purchased a new A2 laser cutter from China and a LAOS controller board to upgrade it. The laser was delivered in January 2015 and work is currently underway integrating it into the hackspace RFID system so usage can be tracked. Its anticipated that things should be up and running by mid to late February.

After the upgrade the laser is controlled with Visicut. The configuration for Visicut can be automatically installed (as of Mid Feb 2015) by simply selecting Leeds Hackspace from the list of laser cutters on first installation.

A laser induction is required before use.

Capabilities

The laser should cut:

  • Acrylic sheet
  • Plywood
  • MDF
  • Paper
  • Card (with the exception of corrugated card)

You should NOT cut:

  • Vinyl (toxic/corrosive fumes)
  • Lexan (different toxic fumes)
  • Corrugated card (fire risk)
  • Food (it smells horrible and gunges up the laser)

Stuff that *might* be etchable (this will be covered in induction):

  • Metal
  • Glass
  • Ceramics

All of the above need their reflectiveness dealing with or you could damage the laser.

Anything not mentioned above, ask a Laser-inducted director and do not be surprised/upset when they say "hell no!".

Maintenance

  • After use
    • Allow laser to cool with water still running before powering off.
    • Vacuum out any laser crud that's on/under the bed.
    • Ensure you've left the laser clean and tidy.
    • Remember your RFID card!
  • Periodic
    • Clean optics.
    • Check coolant levels, top up with distilled water if necessary.
    • Check vent tube for any escaped laser crud.

Installation Checklist

  • Mount laser on trolley - DONE
  • Drill wall for vent - DONE
  • Install & fix vent tube - DONE
  • Vent to laser flexi tube coupling - DONE
  • Cut vent flange gasket
  • Cut new control panel
  • RFID access
  • Grand opening