Laser Cutter Settings: Difference between revisions
Jump to navigation
Jump to search
(Creating Settings Page) |
(Updated settings and added note about Mark Deep problem) |
||
| (One intermediate revision by one other user not shown) | |||
| Line 11: | Line 11: | ||
| 3mm Acrylic Cut | | 3mm Acrylic Cut | ||
| 100 | | 100 | ||
| | | 7 | ||
|- | |- | ||
| 3mm Acrylic Engrave (dither) | | 3mm Acrylic Engrave (dither) | ||
| Line 22: | Line 22: | ||
|- | |- | ||
| 3mm Acrylic Mark Shallow | | 3mm Acrylic Mark Shallow | ||
| | | 50 | ||
| 50 | |||
|- | |||
| 3mm Acrylic Mark Deep* | |||
| 100 | |||
| 100 | |||
|- | |||
| 3mm Laser Ply | |||
| 100 | | 100 | ||
| 7 | |||
|- | |- | ||
| 3mm | | 3mm Laser Ply Mark Shallow | ||
| 50 | |||
| 50 | |||
|- | |||
| 3mm Laser Ply Mark Deep* | |||
| 100 | | 100 | ||
| 100 | | 100 | ||
|- | |||
| 150gsm Card | |||
| 40 | |||
| 60 | |||
|} | |} | ||
*Mark Deep has a slight problem of not cutting any line which is within another one (i.e. it can only Mark Deep jam doughnuts, not ring doughnuts) so it is better to just adjust the settings for Mark Shallow instead. | |||
Latest revision as of 16:59, 2 May 2018
Laser cutter settings
Below are recommended settings for some known materials. If you want to cut something other than these, please experiment on scrap/spare material and update the table
| Material | Power | Speed
(cut) |
|---|---|---|
| 3mm Acrylic Cut | 100 | 7 |
| 3mm Acrylic Engrave (dither) | 90 | 100 |
| 3mm Acrylic Engrave (solid) | 55 | 100 |
| 3mm Acrylic Mark Shallow | 50 | 50 |
| 3mm Acrylic Mark Deep* | 100 | 100 |
| 3mm Laser Ply | 100 | 7 |
| 3mm Laser Ply Mark Shallow | 50 | 50 |
| 3mm Laser Ply Mark Deep* | 100 | 100 |
| 150gsm Card | 40 | 60 |
- Mark Deep has a slight problem of not cutting any line which is within another one (i.e. it can only Mark Deep jam doughnuts, not ring doughnuts) so it is better to just adjust the settings for Mark Shallow instead.