Workshop/Bench Grinder & Sander

From Leeds Hackspace Wiki
Revision as of 09:56, 10 September 2016 by Ad (talk | contribs) (Maintenance, cleaning up, safety, more consumables)
Jump to: navigation, search
Bench Grinder & Sander
Equipment Information
Status Unknown
Manufacturer WorkZone (Aldi)
Model TBSG-240-2013UK
Hackspace Information
Induction Required No
Card RFID Enabled No
Owner Hackspace

The Basics

This is a multi-use tool. The grinding wheel portion can be used to grind carbon steels such as High Speed Steel toolbits, and the sanding belt can be used for pretty much everything else. Because the sanding belt size is a little bit odd (it is longer than normal) it can be difficult to find grits finer than 80.

  • 150 mm dia x 20 mm grinding wheel (12.7 mm bore)
  • 50 mm x 686 mm sanding belt
  • 2950 RPM

No specific induction is required to use this machine, but it is important to understand the hazards involved with using a grinding wheel. Please ask if you are unsure whether what you are doing is safe.


  • Long hair MUST be tied up, long sleeves should be rolled up securely.
  • Eye protection MUST be worn. Safety glasses are in the "Safety Equipment" box.
  • Ensure appropriate guards are in place. This includes ensuring that there is not an overly large gap between the edge of the tool rest and the grinding wheel.
  • Be careful what you shower in hot sparks.
  • The working face of the grinding wheel is the short one at the front of the machine. Do not grind materials on the long sides.
  • Grinding wheels should be handled with care.

Acceptable materials

  • For a quick intro into what you can grind on this Aluminium Oxide wheel, check out this link.
  • Do not grind non-ferrous metals such as aluminium or copper on the wheel. this can lead to dangerous situations, such as the wheel exploding at high speed.
  • If you accidentally load up the wheel with something inappropriate do not worry - simply dress the wheel using the procedure below.

Cleaning up

Once you have finished using the grinding wheel, grab the hoover and suck up your dust. Please leave the machine in a cleaner state than you found it. In particular try not to leave sawdust everywhere.


Dressing the wheel

Although it doesn't seem like it the grinding wheel is a consumable item - it just doesn't wear down very quickly. If the cutting isn't going as well as it usually is, perhaps the work-piece is just heating up and not grinding the likelihood is that it needs "dressing" to expose fresh, sharp cutting surfaces and remove gouges introduced by day to say use.

  • Breathing protection is required. This process releases a large amount of unpleasant dust that you should not breathe.
  • Turn on the grinder
  • Using the T shaped diamond dressing tool, press the rough diamond edges against the working face of the grinding wheel.
  • Move the dressing tool back and forth until fresh grinding surface is uniformly exposed.
  • Try to make the new cutting face as square to the direction of rotation as possible.
  • Hoover up the dust produced.

If you are unsure how to safely perform this procedure, ask someone. The mailing list or Slack/IRC is a good place to start.

Replacing the belt

This is quite an involved process which includes balancing the belt after it has been replaced. Instructions coming soon!

Replacement Consumables