Electronics/OX800: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Category:Tools_and_Equipment]] | |||
[[Category:Electronics]] | |||
{{Equipment | {{Equipment | ||
| title = Oscilloscope | | title = Oscilloscope | ||
| Line 4: | Line 6: | ||
| manufacturer = ITT Instruments | | manufacturer = ITT Instruments | ||
| model = Metrix OX800 | | model = Metrix OX800 | ||
| image = | | image = IttOX800.JPG | ||
| owner = Hackspace & Members | | owner = Hackspace & Members | ||
| induction = TBD | | induction = TBD | ||
| Line 15: | Line 17: | ||
== Specification == | == Specification == | ||
[[File:ITTOX800-starburst.JPG|250px|thumb|right|Starburst, created using X-Y mode and 2 signal generator outputs]] | |||
* ITT Instruments Metrix OX800 | * ITT Instruments Metrix OX800 | ||
* Bandwidth: 20MHz, needs confirming | * Bandwidth: 20MHz, needs confirming | ||
| Line 23: | Line 25: | ||
* 200ms to 0.5us horizontal | * 200ms to 0.5us horizontal | ||
* Component tester | * Component tester | ||
* Issues: [31 March 2016] Functional. Horizontal and vertical | * X-Y mode | ||
* Issues: [31 March 2016] Functional. Horizontal and vertical deflection are slightly off cal (about 5%), when compared against the Hameg 1KHz 2v cal point | |||
* Manual: TBD | * Manual: TBD | ||
* Owner: TBD | * Owner: TBD | ||
== Calibration == | == Calibration == | ||
| Line 37: | Line 42: | ||
== Safety == | == Safety == | ||
[[Electronics/safety|You must read the safety documentation in this link before using this equipment.]] | |||
== Useful References == | == Useful References == | ||
Latest revision as of 15:32, 28 December 2017
 | |
| Analogue oscilloscope | |
| Equipment Information | |
|---|---|
| Status | Unknown |
| Manufacturer | ITT Instruments |
| Model | Metrix OX800 |
| Hackspace Information | |
| Induction Required | Yes |
| Induction Information | Here |
| Card RFID Enabled | No |
| Owner | Hackspace & Members |
The Basics
An oscilloscope is a piece of electrical test equipment which allows you to visually see an electrical signal shown on a display.
Specification
- ITT Instruments Metrix OX800
- Bandwidth: 20MHz, needs confirming
- Analogue Cathode ray tube (CRT)
- 2 channel + Ext trigger
- 20v to 1mv vertical
- 200ms to 0.5us horizontal
- Component tester
- X-Y mode
- Issues: [31 March 2016] Functional. Horizontal and vertical deflection are slightly off cal (about 5%), when compared against the Hameg 1KHz 2v cal point
- Manual: TBD
- Owner: TBD
Calibration
The spaces oscilloscopes will NOT normally have a calibration certificate. Most will be well outside their calibration date. Having said that it is common to perform a basic oscilloscopes calibration check before each use against a known calibration source to confirm it is suitable for use. Most oscilloscopes have a calibration signal output point on the front panel. Some have rear panel outputs.
Induction
Ask on the mailing list for volunteers to demonstrate the use of any of the test equipment.
Safety
You must read the safety documentation in this link before using this equipment.