Lulzbot Mini

Thanks to the Hackspace Foundation and Lulzbot, we have acquired a Lulzbot Mini (https://www.lulzbot.com/store/printers/lulzbot-mini) which is a 3mm filament based 3D Printer.

The LulzBot Mini is well documented (https://www.lulzbot.com/support) with software support for Linux, Windows and Mac with their version of Cura (https://www.lulzbot.com/cura) this software is also used to upgrade the firmware on the LulzBot.

The LulzBot Mini 1 firmware is based on Marlin (http://download.lulzbot.com/Software/Marlin/1.1.9.28/Marlin_Mini_SingleExtruder_1.1.9.28_193d1f804.hex / https://www.lulzbot.com/content/downloads)

If you want to begin using the LulzBot Mini then you should start by following the Quick Start Guide so you're at least familiar with how it is setup.

https://www.lulzbot.com/cura-lulzbot-edition-quick-start-guide http://download.lulzbot.com/Mini/1.04/documentation/Quick_Start_Guide/Mini_1.04_Quick_Start_Guide_FINAL.pdf

There is also a user manual: http://download.lulzbot.com/Mini/1.04/documentation/Manual/interior_9780989378468.pdf

And a 'cheat sheet' poster: http://download.lulzbot.com/Mini/1.0/documentation/Mini_Poster_11x17.pdf

Latest versions of documentation and similar can be found here, including replacement 3D printable parts: http://download.lulzbot.com/Mini/1.04/

(Any content in Mini/2 and above is for a different version of the LulzBot Mini 3D Printer)

Please be aware of the following safety considerations for the LulzBot Mini: http://download.lulzbot.com/Mini/1.04/documentation/safety_warnings/safety_warnings_LulzBot_Mini.pdf